Hello, i tried since 2 days to get my ENC28J60 to work with a Vampire 500 V2+ Revision 2.2 but i cant get it to work.
My Ethernetadapter has 3.3V and is an ENC28J60. The 1:1 cable dont work because my adapter has 12 pins and not 10, so i need to set every pin by my own.
The wiki article dont help! There is only the pinout for the old V500 but not the new one.
Can anybody please help me?
Igor Majstorovic (Apollo Team Member) Posts 408 22 Jan 2020 19:03
Can you please post picture of your adapter. But, definitely, I would order adapter we propose, it is very cheap and you can buy it easily.
The pin out is right there, printed on the module in the picture. And it’s says it’s a 5v module
Patrik Rendel
Posts 32 22 Jan 2020 19:46
Yes it can be used with both 5V and 3.3V and Q3 means 3.3V
Martin White
Posts 85 22 Jan 2020 19:53
Ah ok. See what you mean now. Given the device on the wiki uses a flat ribbon cable you should be able to see where those 10 pins connect onto your 12 pin device
Patrik Rendel
Posts 32 22 Jan 2020 21:11
This is that what i did and dont work.
where is the problem to say what the pinout is from the new revision and why are there 10 pins if only 7 are in use?
Igor Majstorovic (Apollo Team Member) Posts 408 22 Jan 2020 21:29
Problem is that you need to wait for someone to reply to you and to resolve problem you have with the device we didn't recommend to use. I have no idea can that work at all because same chip can be interfaced by number of ways.
EDIT: I m trying to make some picture that could help you, pls be patient. EXTERNAL LINK
Patrik Rendel
Posts 32 22 Jan 2020 22:31
REALLY BIG THANKS!!!!!!!!!
I got it now to work with your help and the pinout :) I write this text from my A500 now ;)
Igor Majstorovic (Apollo Team Member) Posts 408 22 Jan 2020 22:38